The zero sequence impedance per phase is three times the impedance measured in this manner. The zero sequence is required for earth fault protection and earth fault current calculations.
- it
- en
- Home
- Products
- Products
- Transformer Monitoring
- Transformer Measurements
- Fiber Optic Sensors
- Bushings
- Tests & Measurements on Switches & Disconnectors
- Partial Discharge & Tan Delta
- Measurement Services
- High Voltage Tests, Measurements & Adjustments
- Transformer Oil Treatment
- Power Resistors for Industry, Energy & Traction
- Impact & Shock Recorder for Transports
- Remote Control & Monitoring Devices
- Services
- Services
- Low Voltage Measurement
- Low voltage measurement
- Measurement Voltage ratio and Phase displacement
- Measurement magnetizing current
- Measurement of winding resistance
- Dynamic OLTC-Scan
- Determination of capacitances windings-bushings and measuring dissipation factor
- Measurement of short-circuit impedance
- Measurement of d.c. insulation resistance between each winding, core, clamps, shield
- Measurement of Zero sequence(S)
- Measurement of frequency response analysis (FRA)
- Measurement of Dielectric Frequency Response (DFR)
- Measurement of CT (ratio, polarity, ohmic resistance , knee point)
- High Voltage test
- Low frequency Heating +OTP
- Bushings replacement
- News
- Contact
- About Us
- it
- en